![]() Then use the diagnostic equipment and its attached diagnostic connector, and follow the on-screen instructions to complete the re-learning operation. ![]() To perform the OBD re-learning function, first use the tire pressure tool to activate all four tire sensors. This function allows the diagnostic equipment to directly write the sensor ID to the TPMS module. Static learning needs to put the vehicle in “learning mode”, and then follow the learning steps prompted on the screen.įor some vehicles, the learning function can be completed by driving the vehicle self-learning. Only when the newly programmed sensor ID is different from the original sensor ID stored in the vehicle ECU, the re-learning operation is required.Ī total of three sensor learning methods are provided: static learning, self-learning and OBD re-learning The user can use this function to write the newly programmed sensor ID into the vehicle ECU for sensor identification. 3, fill in the information in each field and then tap Register, a screen similar to the following will appear: B.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |